Connect the device using an ad hoc wireless network connection
Method 1
1. Turn on wireless in your computer and in the device.
2. On your computer, connect to the network name (SSID) “hpsetup“. (This network name is the
default, ad hoc network created by the HP device.)
NOTE: If your HP device was previously configured for a different network, you can restore
the network defaults to enable the device to use “hpsetup“. To restore the network defaults
complete the following steps:
Reset the administrator password and network settings: Select Setup, select
Network, and then select Restore Network Defaults. For more information, see
General
troubleshooting tips and resources
.
Appendix D
202
Network setup (some models only)